Six maintenance skills of Computerized flat knitting machine

Computerized flat knitting machine cleaning and maintenance:

After the needle groove is used for a long time, there will be fouling in the groove, which directly affects the quality of knitwear, so the needle bed must be wiped regularly. It is called cleaning the car, and the following points must be paid attention to when cleaning the car:

1. Push all the knitting needles to the knitting area to prevent the needle latch from being damaged when pulling the upper stopper iron.

2. The extracted upper and lower plug irons and needle bed pressure irons must be placed on the workbench in the original order. Do not make mistakes and are easy to install.

3. If you find rust spots on the needle bed, use No. 0 emery cloth to sand and smooth it. Do not wipe the grid-shaped teeth of the needle bed to avoid damaging the straightness of the teeth.

4. Do not wipe the emery cloth on the "front" of the plug iron, so as to avoid the damage of the "front" and affect the operation of pressing the needle.

Basic electrical performance of computerized flat knitting machine

1) The computerized flat knitting machine should be able to work normally under the condition of power supply voltage 220 (1±10%) V or 380 (1±110%) V. In a 380V circuit, it can withstand 2200V/50Hz: AC sinusoidal voltage, and there should be no damage within 1 min.

2) The insulation resistance between the live parts of different polarities and between the live parts and the shell of the computerized flat knitting machine should meet the cold state resistance ≥ 20mΩ, and the hot state resistance ≥ 2mΩ